1Rectifier Device Data
DPAK Power Surface Mount Package
. . . employing the Schottky Barrier principle in a large area metal–to–silicon
power diode. State of the art geometry features epitaxial construction with oxide
passivation and metal overlay contact. Ideally suited for low voltage, high
frequency switching power supplies, free wheeling diode and polarity protection
diodes.
•Highly Stable Oxide Passivated Junction
•Guardring for Stress Protection
•Matched dual die construction – May be Paralleled for High Current Output
•High dv/dt Capability
•Short Heat Sink Tap Manufactured – Not Sheared
•Very Low Forward Voltage Drop
•Epoxy Meets UL94, VO at 1/8”
Mechanical Characteristics:
•Case: Epoxy, Molded
•Weight: 0.4 gram (approximately)
•Finish: All External Surfaces Corrosion Resistant and Terminal Leads are
Readily Solderable
•Lead and Mounting Surface Temperature for Soldering Purposes:
260°C Max. for 10 Seconds
•Shipped in 75 units per plastic tube
•Available in 16 mm Tape and Reel, 2500 units per Reel,
Add “T4’’ to Suffix part #
•Marking: B1035CL
MAXIMUM RATINGS
Rating Symbol Value Unit
Peak Repetitive Reverse Voltage
Working Peak Reverse Voltage
DC Blocking Voltage
VRRM
VRWM
VR
35 Volts
Average Rectified Forward Current Per Leg
(At Rated VR, TC = 115°C) Per Package IO5
10 Amps
Peak Repetitive Forward Current Per Leg
(At Rated VR, Square Wave, 20 kHz, TC = 115°C) IFRM 10 Amps
Non–Repetitive Peak Surge Current Per Package
(Surge applied at rated load conditions, halfwave, single phase, 60 Hz) IFSM 50 Amps
Storage / Operating Case Temperature Tstg, Tc–55 to +125 °C
Operating Junction Temperature TJ–55 to +125 °C
Voltage Rate of Change (Rated VR, TJ = 25°C) dv/dt 10,000 V/µs
THERMAL CHARACTERISTICS
Thermal Resistance – Junction to Case Per Leg RθJC 2.43 °C/W
Thermal Resistance – Junction to Ambient (1) Per Leg RθJA 68 °C/W
(1) Rating applies when using minimum pad size, FR4 PC Board
SWITCHMODE is a trademark of Motorola, Inc.
This document contains information on a new product. Specifications and information herein are subject to change without notice.
Motorola, Inc. 1998
Order this document
by MBRD1035CTL/D
SEMICONDUCTOR TECHNICAL DATA
SCHOTTKY BARRIER
RECTIFIER
10 AMPERES
35 VOLTS
CASE 369A–13
DPAK
13
4
1
3
4
MBRD1035CTL
2Rectifier Device Data
ELECTRICAL CHARACTERISTICS
Maximum Instantaneous Forward Voltage(2), see Figure 2 Per Leg
IF = 5 Amps, TJ = 25°C
IF = 5 Amps, TJ = 100°C
IF = 10 Amps, TJ = 25°C
IF = 10 Amps, TJ = 100°C
VF0.47
0.41
0.56
0.55
Volts
Maximum Instantaneous Reverse Current, see Figure 4 Per Leg
(VR = 35 V, TJ = 25°C)
(VR = 35 V, TJ = 100°C)
(VR = 17.5 V, TJ = 25°C)
(VR = 17.5 V, TJ = 100°C)
IR2.0
30
0.20
5.0
mA
(2) Pulse Test: Pulse Width ≤ 250 µs, Duty Cycle ≤2.0%.
TYPICAL CHARACTERISTICS
Figure 1. Typical Forward Voltage Per Leg Figure 2. Maximum Forward Voltage Per Leg
Figure 3. Typical Reverse Current Per Leg
1.100.10 VF, INSTANTANEOUS FORWARD VOLTAGE (VOLTS)
100
10
VR, REVERSE VOLTAGE (VOLTS) 350
100E–6
1E–6
IF, INSTANTANEOUS FORWARD CURRENT (AMPS)
I
1.0
0.500.30 0.70 0.90
10 20 30
10E–3
100E–3
0.1
, REVERSE CURRENT (AMPS)
R
1E–3
10E–6
TJ = 25
°
C
TJ = 100
°
C
TJ = 125
°
C
TJ = – 40
°
C
TJ = 125
°
C
Figure 4. Maximum Reverse Current Per Leg
1.100.10VF, MAXIMUM INSTANTANEOUS FORWARD VOLTAGE (VOL TS)
100
10
IF, INSTANTANEOUS FORWARD CURRENT (AMPS)
1.0
0.500.30 0.70 0.90
0.1
TJ = 25
°
C
TJ = 100
°
C
TJ = 125
°
C
1E+0
TJ = 100
°
C
TJ = 25
°
C
VR, REVERSE VOLTAGE (VOLTS) 350
100E–6
1E–6 10 20 30
10E–3
100E–3
1E–3
10E–6
TJ = 125
°
C
1E+0
TJ = 100
°
C
TJ = 25
°
C
I , MAXIMUM REVERSE CURRENT (AMPS)
R
MBRD1035CTL
3Rectifier Device Data
Figure 5. Current Derating Per Leg Figure 6. Forward Power Dissipation Per Leg
Figure 7. Capacitance Per Leg
1200
TL, LEAD TEMPERATURE (
°
C)
8.0
7.0
5.0
6.0
4.0
VR, DC REVERSE VOLTAGE (VOLTS)
250
105
85
75
65
0
VR, REVERSE VOLTAGE (VOLTS)
100
10
IO, A VERAGE FORWARD CURRENT (AMPS)
C, CAPACITANCE (pF)
3.0
2.0
1.0
6020 40 80 100 140
30 355101520
95
115
125
510152025
0
T
J
, DERATED OPERATING TEMPERATURE ( C)
1000 TJ = 25
°
C
freq = 20 kHz
Ipk/Io =
p
Ipk/Io = 20
dc
SQUARE W AVE
(50% DUTY CYCLE)
IO, A VERAGE FORWARD CURRENT (AMPS)
1.00
4.0
3.0
2.0
1.0
02.0
PFO, AVERAGE POWER DISSIPA TION (WATTS)
3.0 4.0 5.0 6.0 7.0 8.0
3.5
2.5
1.5
0.5
Ipk/Io = 20
SQUARE W AVE
(50% DUTY CYCLE) dc
Figure 8. Typical Operating Temperature
Derating Per Leg *
Ipk/Io = 10
Ipk/Io = 5 Ipk/Io = 10
Ipk/Io = 5
Ipk/Io =
p
°
R
q
JA = 84
°
C/W
R
q
JA = 67.5
°
C/W
R
q
JA = 48
°
C/W
R
q
JA = 25
°
C/W
R
q
JA = 2.43
°
C/W
* Reverse power dissipation and the possibility of thermal runaway must be considered when operating this device under any re-
verse voltage conditions. Calculations of TJ therefore must include forward and reverse power effects. The allowable operating
TJ may be calculated from the equation: TJ = TJmax – r(t)(Pf + Pr) where
r(t) = thermal impedance under given conditions,
Pf = forward power dissipation, and
Pr = reverse power dissipation
This graph displays the derated allowable TJ due to reverse bias under DC conditions only and is calculated as TJ = TJmax – r(t)Pr,
where r(t) = Rthja. For other power applications further calculations must be performed.
MBRD1035CTL
4Rectifier Device Data
Figure 9. Thermal Response Junction to Case (Per Leg)
Figure 10. Thermal Response Junction to Ambient (Per Leg)
0.10.00001
t, TIME (s)
1.0
0.1
0.01
r
0.0001 0.001 0.01
, TRANSIENT THERMAL RESISTANCE (NORMALIZE
D
(t)
1.0 10 100 1000
50%(DUTY CYCLE)
20%
10%
5.0%
2.0%
1.0%
Rtjl(t) = Rtjl
•
r(t)
0.10.00001
t, TIME (s)
1.0E+00
1.0E–01
1.0E–02
1.0E–03
1.0E–04 0.0001 0.001 0.01 1.0 10 100 10000
50% (DUTY CYCLE)
20%
10%
5.0%
2.0%
1.0%
SINGLE PULSE
r , TRANSIENT THERMAL RESISTANCE (NORMALIZED)
(t)
1000
SINGLE PULSE
Rtjl(t) = Rtjl
•
r(t)
MBRD1035CTL
5Rectifier Device Data
PACKAGE DIMENSIONS
CASE 369A–13
ISSUE Y
D
A
K
B
R
V
S
FL
G
2 PL
M
0.13 (0.005) T
E
C
U
J
H
–T–
SEATING
PLANE
Z
DIM MIN MAX MIN MAX
MILLIMETERSINCHES
A0.235 0.250 5.97 6.35
B0.250 0.265 6.35 6.73
C0.086 0.094 2.19 2.38
D0.027 0.035 0.69 0.88
E0.033 0.040 0.84 1.01
F0.037 0.047 0.94 1.19
G0.180 BSC 4.58 BSC
H0.034 0.040 0.87 1.01
J0.018 0.023 0.46 0.58
K0.102 0.114 2.60 2.89
L0.090 BSC 2.29 BSC
R0.175 0.215 4.45 5.46
S0.020 0.050 0.51 1.27
U0.020 ––– 0.51 –––
V0.030 0.050 0.77 1.27
Z0.138 ––– 3.51 –––
NOTES:
1. DIMENSIONING AND TOLERANCING PER ANSI
Y14.5M, 1982.
2. CONTROLLING DIMENSION: INCH.
123
4
MBRD1035CTL
6Rectifier Device Data
Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty, representation or guarantee regarding
the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit, and
specifically disclaims any and all liability, including without limitation consequential or incidental damages. “Typical” parameters which may be provided in Motorola
data sheets and/or specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including “Typicals”
must be validated for each customer application by customer’s technical experts. Motorola does not convey any license under its patent rights nor the rights of
others. Motorola products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other
applications intended to support or sustain life, or for any other application in which the failure of the Motorola product could create a situation where personal injury
or death may occur. Should Buyer purchase or use Motorola products for any such unintended or unauthorized application, Buyer shall indemnify and hold Motorola
and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees
arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that
Motorola was negligent regarding the design or manufacture of the part. Motorola and are registered trademarks of Motorola, Inc. Motorola, Inc. is an Equal
Opportunity/Af firmative Action Employer.
Mfax is a trademark of Motorola, Inc.
How to reach us:
USA/EUROPE/Locations Not Listed: Motorola Literature Distribution; JAPAN: Nippon Motorola Ltd.: SPD, Strategic Planning Office, 141,
P.O. Box 5405, Denver, Colorado 80217. 1–303–675–2140 or 1–800–441–2447 4–32–1 Nishi–Gotanda, Shagawa–ku, Tokyo, Japan. 03–5487–8488
Customer Focus Center: 1–800–521–6274
Mfax: RMFAX0@email.sps.mot.com – TOUCHTONE 1–602–244–6609 ASIA/PACIFIC: Motorola Semiconductors H.K. Ltd.; 8B Tai Ping Industrial Park,
Motor ol a F ax Ba ck System – US & Canada ONLY 1–800–774–1848 51 T ing Kok Road, Tai Po, N.T., Hong Kong. 852–26629298
– http://sps.motorola.com/mfax/
HOME PAGE: http://motorola.com/sps/
MBRD1035CTL/D
◊