Hardware & S oftware Description
The XPort unit is a complete solution (hardware and
software) for web-enabling your edge devices. Packed
into an RJ45 connector smaller than your thumb, this
powerful device server comes with a 10BASE-
T/100BASE-TX Ethernet connection, a reliable and
proven operating system stored in flash memory, an
embedded web server, a full TCP/IP protocol stack,
and standards-based (AES) encryption.
The XPort software runs on a DST ni EX controller
which has 256 KB of SRAM, 16 KB of boot ROM, and
a MAC with integrated 10/100BASE-TX PHY. The
XPort module communicates to the edge device
through a 3.3V serial interface and three general-
purpose progr am mable I/O pins. 512 KB of flas h
memory is included for storing firmware and web
pages. The XPort runs on 3.3V, and has a built-in
voltage supervisory circuit that will trigger a reset if the
supply voltage drops to unreliable levels (2.7V). A
built-in 1.8V regulator drives the processing core of
the EX controller.
An RJ45 Ethernet cable connects directly into an
XPort unit. Ethernet magnetics, status LEDs, and
shielding are built in. The XPort module was designed
to meet class B emissions levels, which makes the
electromechanical integration very simple.
PCB Inte rf ac e
The 8-pin PCB interface consists of 3.3V CMOS
Serial In/Out, 3 Flow Control/Handshake/PIO pins,
reset input, +3.3V power, and signal ground. The
serial pins and CP pins are 5V tolerant. RESET and
Power are 3.3V tolerant.
Table 1 - PCB Interface Signals
CP1 6
CP1 can be configured as follows:
•Flow control: RTS (Request to Send)
output driven by DSTni’s built-in UART
for connecti on to CTS of attached
device.
•Programmable input/output: CP1 can
be driven or read through software
control, independent of serial port
CP2 7
CP2 can be configured as follows:
•Modem control: DTR (Data Terminal
Ready) output driven by DSTni’s built-
in UART for connection to DCD of
attached device.
•Programmable input/output: CP2 can
be driven or read through software
control, independent of serial port
CP3 8
CP3 can be configured as follows:
•Flow control: CTS (Clear to Send)
input read by DSTni’s built-in UART for
connection t o RTS of attached device.
•Modem control: DCD (Data Carrier
Detect) input read by DSTni’s built-in
UART for connectio n to D TR of
attached device.
•Programmable input/output: CP3 can
be driven or read through software
control, independent of serial port
Ethernet Interface
The 10/100 Ethernet magnetics, network status
LEDs, and RJ45 connector are integrated into the
XPort unit.
Table 2 - Ethernet Interface Signals
TX+ Out 1 Transmit Dat a +
TX- Out 2 Transm it Data –
RX+ In 3 Receive Data +
RX- In 6 Receive Data –
Not Used 4 Terminated
Not Used 5 Terminated
Not Used 7 Terminated
Not Used 8 Terminated
SHIELD Chassis Ground
910-815I XPort Embedded Device Server Data Sheet Copyright© 2014, Lantronix. All rights reserved.