Features
Regulated
Converters
• Wide 4:1 Input Voltage Range
• 1.6kVDC Isolation
• UL Certified
• Efficiency up to 88%
• Fixed Operating Frequency
• Six-Sided Continuous Shield
PD-1
REV.: 1/2016www.recom-power.com
DC/DC Converter
3
Y
E
A
R
w
a
r
r
a
n
t
y
3
Description
The RP15-AW series are ultraminiature wide input voltage range power DC/DC converters in a case
half the size of industry standard 15W converters. Despite their small size, the RP15-AW converters
are fully specified devices with output currents up to 4 Amps, no minimum load, 1600VDC isolation
and low ripple/noise figures. The outputs are also fully protected against short circuits, overcurrent and
overvoltage. The RP15-AW series will find many uses in applications where board space and/or board
height is at a premium.
E196683
15 Watt
Single &
Dual
Output
RP15-AW
Selection Guide
Part Number Input Output Output Input(1) Efficiency(1) Max. Capacitive
Voltage Range Voltage Current Current typ. Load(2)
[VDC] [VDC] [mA] [mA] [%] [µF]
RP15-243.3SAW(3,4) 9-36 3.3 4000 640 86 12000
RP15-2405SAW(3,4) 9-36 5 3000 727 86 6000
RP15-2412SAW(3,4) 9-36 12 1300 747 87 1000
RP15-2415SAW(3,4) 9-36 15 1000 718 87 660
RP15-483.3SAW(3,4) 18-75 3.3 4000 320 86 12000
RP15-4805SAW(3,4) 18-75 5 3000 359 87 6000
RP15-4812SAW(3,4) 18-75 12 1300 374 87 1000
RP15-4815SAW(3,4) 18-75 15 1000 359 87 660
RP15-2405DAW(3,4) 9-36 ±5 ±1500 735 85 ±3000
RP15-2412DAW(3,4) 9-36 ±12 ±625 718 87 ±520
RP15-2415DAW(3,4) 9-36 ±15 ±500 710 88 ±330
RP15-4805DAW(3,4) 18-75 ±5 ±1500 368 85 ±3000
RP15-4812DAW(3,4) 18-75 ±12 ±625 363 86 ±520
RP15-4815DAW(3,4) 18-75 ±15 ±500 359 87 ±330
UL60950-1 Certified
Ordering Examples
RP15-2405SAW/P = 24V 4:1 Input, 5V Output, Positive Logic CTRL pin and Trim pin fitted.
RP15-4805DAW-HC = 48V 4:1 Input, ±5V Output, Premounted Heat-sink
(no trim pin with dual output)
Model Numbering
Input Voltage
Output Voltage
Single or Dual
RP15-__ __ _AW/_ _
Notes:
Note3: Standard part is without suffixes and Trim and CTRL pins are not fitted.
add suffix “P” for CTRL function with positive logic (1=ON, 0=OFF) and trim pin for single output
add suffix “N” for CTRL function with negative logic (0=ON, 1=OFF) and trim pin for single output
Note4: add suffix -HC for premounted Heat-sink and clips
Package(4)
Control Logic(3)
Notes:
Note1: Values at nominal input voltage and full load.
Note2: Test by minimum Vin and constant resistor load.